cancel
Showing results for 
Search instead for 
Did you mean: 

Tow haul mode?

ib_leblanc
Explorer
Explorer
Pulling 10,000 lb fifth wheel with f350, 6.4 deisel.. do you have to always use tow haul mode even on flat interstates?
58 REPLIES 58

JohnBoyToo
Explorer
Explorer
If we r taking a poll, I only use mine when slowing down....
Even when not towing as the engine braking and tranny downshifts save my brake pads ( which aren't under warranty)

Other than slowing I don't usually use it as it holds the gears too long IMHO :.

And since its my truck hope I can drive it like I want to 🙂

Amdavis76
Explorer
Explorer
I like tow/haul mode because downshifts sooner to respond to hills, holds the gear longer, and engine-breaking automatically occurs at higher speeds.
2013 1500 Chevy PU/Crew LT

JustLabs
Explorer
Explorer
I don't like the way the transmission shifts in T/H,so unless I want the grade brake feature,I don't use it.

Pulling my 11,000lb trailer or my 10,000lb boat,the transmission actually runs cooler without T/H.
2011 Chevrolet 2500HD LTZ 4x4 CCLB Duramax/Allison
2007 Keystone Cougar 289BHS Fifth Wheel.

avvidclif1
Explorer
Explorer
Atom Ant wrote:
avvidclif1 wrote:
Here's the explanation on the 6.4 Ford operation.

"I’ll try to explain. Exhaust braking closes off (blocks) the exhaust manifold, leaving the exhaust gases in the cylinders to compress and slow down the engine. Engine braking doesn’t allow fuel to be injected into the cylinder, so a vacuum is created in the cylinders, which slows down the engine, which is connected to the transmission and slows the truck down."

Copied from The Diesel Stop".

All I know is it works. Cruise control set on 60mph. It held it at 60mph down a long 6% (marked) grade. I never touched the brake. Grossing 18,100 lbs.

Proved it to me.

PS A jake brake and an exhaust brake are different things. Look up how a jake brake works on a big truck, no flapper vales, all done by holding open valves.
The 6.4 doesn't have an exhaust brake - the 6.7 does.

What you describe is correct for the 6.4, just simple engine braking combined with the integrated brake controller and tow haul telling the torgueshift when to shift.

Not sure where the "jake brake" came into the discussion.


Jake brake was an aside.

A diesel engine has almost zero engine braking as thought of in a gas engine. Ergo the exhaust brake to create a restriction. On the 6.4 Ford did things with the turbo to create a working "engine brake".
Clif & Millie
2009 Ford F350 SRW CC Lariat 6.4 Diesel
2015 Heartland Cyclone HD CY3418 Toy Hauler

Atom_Ant
Explorer
Explorer
I think it is disabled if you come out of tow haul. Tow haul in itself can cause complications on ice
2008 Ford F350 2014 Redwood 36RL - Our Rig
Onan 5500, Splendide Ariston W/D, 8K axles, disk brakes, G614s, tri-glide pin box,
6-pt leveling, dual heat pump, dual awnings, Trav'ler SK-1000 Dish

stickdog
Explorer
Explorer
I have read where using exhaust brake on wet or snow slick roads is an invitation for disaster. If that is true, then an integrated exhaust brake with TH would prohibit use of that function under those conditions?
9-11 WE WILL NEVER FORGET!
FULLTIME SINCE 2010
17 DRV MS 36rssb3
17 F350 King Ranch CC DRW 4x4 6.7 4:10 B&W hitch
John
“A good traveler has no fixed plans, and is not intent on arriving.” Lao Tzu

Atom_Ant
Explorer
Explorer
avvidclif1 wrote:
Here's the explanation on the 6.4 Ford operation.

"I’ll try to explain. Exhaust braking closes off (blocks) the exhaust manifold, leaving the exhaust gases in the cylinders to compress and slow down the engine. Engine braking doesn’t allow fuel to be injected into the cylinder, so a vacuum is created in the cylinders, which slows down the engine, which is connected to the transmission and slows the truck down."

Copied from The Diesel Stop".

All I know is it works. Cruise control set on 60mph. It held it at 60mph down a long 6% (marked) grade. I never touched the brake. Grossing 18,100 lbs.

Proved it to me.

PS A jake brake and an exhaust brake are different things. Look up how a jake brake works on a big truck, no flapper vales, all done by holding open valves.
The 6.4 doesn't have an exhaust brake - the 6.7 does.

What you describe is correct for the 6.4, just simple engine braking combined with the integrated brake controller and tow haul telling the torgueshift when to shift.

Not sure where the "jake brake" came into the discussion.
2008 Ford F350 2014 Redwood 36RL - Our Rig
Onan 5500, Splendide Ariston W/D, 8K axles, disk brakes, G614s, tri-glide pin box,
6-pt leveling, dual heat pump, dual awnings, Trav'ler SK-1000 Dish

avvidclif1
Explorer
Explorer
Here's the explanation on the 6.4 Ford operation.

"I’ll try to explain. Exhaust braking closes off (blocks) the exhaust manifold, leaving the exhaust gases in the cylinders to compress and slow down the engine. Engine braking doesn’t allow fuel to be injected into the cylinder, so a vacuum is created in the cylinders, which slows down the engine, which is connected to the transmission and slows the truck down."

Copied from The Diesel Stop".

All I know is it works. Cruise control set on 60mph. It held it at 60mph down a long 6% (marked) grade. I never touched the brake. Grossing 18,100 lbs.

Proved it to me.

PS A jake brake and an exhaust brake are different things. Look up how a jake brake works on a big truck, no flapper vales, all done by holding open valves.
Clif & Millie
2009 Ford F350 SRW CC Lariat 6.4 Diesel
2015 Heartland Cyclone HD CY3418 Toy Hauler

Atom_Ant
Explorer
Explorer
ol Bombero-JC wrote:
ib_leblanc wrote:
Pulling 10,000 lb fifth wheel with f350, 6.4 deisel.. do you have to always use tow haul mode even on flat interstates?


Looking at the first couple of replies.....
you have reply from a Dodge owner with a 2006 Dodge CTD.
His info is good - but not totally correct. No point in explaining.
Then the Ford owners chime in.

No doubt Chevy (& GMC) D-Max owners will also.

Looks like even some of the FORD owners are posting incorrect info!.:R

Suggest you visit one of the several *BRAND SPECIFIC* diesel forums, so you're getting info pertinent to YOUR brand and year etc.
Also, you will find (working) mechanics and techs furnishing info.

Example: The tow-haul mode for the aforementioned DODGE CTD operates totally different between 2005 & 2006 48RE (Dodge) transmissions.
Obviously, selection and operation of the feature differs from FORD trannys.

For *FORD* diesel forums -and info-, suggest:
The Diesel Stop (dot com)

(there are others for both diesel & gas. Google- Ford diesel forums)


~
Why would anyone go to another forum to get facts - Go to the manufacturer itself.
2008 Ford F350 2014 Redwood 36RL - Our Rig
Onan 5500, Splendide Ariston W/D, 8K axles, disk brakes, G614s, tri-glide pin box,
6-pt leveling, dual heat pump, dual awnings, Trav'ler SK-1000 Dish

ol_Bombero-JC
Explorer
Explorer
ib_leblanc wrote:
Pulling 10,000 lb fifth wheel with f350, 6.4 deisel.. do you have to always use tow haul mode even on flat interstates?


Looking at the first couple of replies.....
you have reply from a Dodge owner with a 2006 Dodge CTD.
His info is good - but not totally correct. No point in explaining.
Then the Ford owners chime in.

No doubt Chevy (& GMC) D-Max owners will also.

Looks like even some of the FORD owners are posting incorrect info!.:R

Suggest you visit one of the several *BRAND SPECIFIC* diesel forums, so you're getting info pertinent to YOUR brand and year etc.
Also, you will find (working) mechanics and techs furnishing info.

Example: The tow-haul mode for the aforementioned DODGE CTD operates totally different between 2005 & 2006 48RE (Dodge) transmissions.
Obviously, selection and operation of the feature differs from FORD trannys.

For *FORD* diesel forums -and info-, suggest:
The Diesel Stop (dot com)

(there are others for both diesel & gas. Google- Ford diesel forums)


~

AnnSnow
Explorer
Explorer
Tow Haul + Cruise Control
Check your truck manual... I drive a chevy diesel. Its tow haul mode not only saves my truck engine (as others have already commented on), but also my truck and trailer brakes....

When going down steep grades: In tow haul mode I set my cruise control to an appropriate speed. Tow haul + cruise control automatically keeps me in the right gear for the grade. I don't have to ride my brakes.

When possible, I anticipate lower speeds needed on curves or hairpins... I'll start with a much lower speed so that when I get to reduced speeds on curves, etc., I still don't have to brake.

Tow haul is your friend!
Ann

Atom_Ant
Explorer
Explorer
hdave wrote:
The Ford doesn't have an exhaust brake.It is a program that is built into the TH Mode
Partially right - The 6.7 does have an exhaust brake, and it's controlled automatically through the tow haul mode.

Tow/Haul Mode with Engine Exhaust Braking Function
2008 Ford F350 2014 Redwood 36RL - Our Rig
Onan 5500, Splendide Ariston W/D, 8K axles, disk brakes, G614s, tri-glide pin box,
6-pt leveling, dual heat pump, dual awnings, Trav'ler SK-1000 Dish

GPG52_
Explorer II
Explorer II
Good response tread, thks for the technical explanation;I knew it helped but did not know the underlying mechanical workings.
Like most I always turn it on when hooked up and just sit back and let it do it's job. GPG
GPG 🙂
2014 Ford F250, 6.2L, 4.30 Ratio, 6 speed
2014 Cougar (by Keystone) 327 RES

hdave
Explorer
Explorer
The Ford doesn't have an exhaust brake.It is a program that is built into the TH Mode
2011 Dodge Ram 3500
2013 Rushmore Lincoln
British Columbia
Canada