I'm getting a 2024 Ram 3500 DRW long bed crew cab truck for my 2000 Bigfoot 10.6 truck camper. My measurements show I'll have about 1.5" clearance between the truck cab and camper overhang at about the center of the cab. I'll have about 1/2" at the...
I'm going to replace my 2 lead acid batteries in my Bigfoot truck camper with two 100ah LiFePO4 batteries. I've previously installed a 4 way battery selector switch to allow me to keep one of my batteries at a high enough charge level to start my ge...
I found a very attractive price for a remanufactured Power Dynamics PD4045CSR replacement converter section. Does anyone know if this can be put into a Magnetec 6332 power center? ThanksSterling
I have a factory installed Onan Microlite 2.5KV propane generator in my 2000 Bigfoot truck camper. It starts and runs fine when the house batteries are fully charged. However, it will crank over fine but not start when the batteries are partially d...
If I have to raise it then I'll probably shoot for more than 1 1/2". If I can get 1 1/2" clearance without raising the camper then I'll probably give it a try. My current truck has 2 1/8" at the minimum clearance point and it has been that way for ...
I'm still waiting for the truck, the scheduled delivery date to the dealer slipped from November 11 to November 19. Depending on how things work out I may not get it until the beginning of December. I contacted Bigfoot to get their input on the min...
It seems like if it did slightly contact at the center of the cab roof that it wouldn't cause any permanent damage but would give me a warning that I need to do something about it. It also depends on how the cab and camper move in relation to each o...
