One of the differences between Digital and Analog.
Channel 2 used to be around 56 MHz (This is the center of a 6 MHZ wide channel)
Channel six was 85
Chan 7 177
chan 13 213
chan 14 to 69 470 to 806 (The full band)
As you go higher in frequency (Shorter in wave length) smaller and smaller objects cause issues.. On 145 MHZ, hams running less than 1,000 watts transmitter power can and have had conservations on paths of hundreds of miles.. I've done several hundred on what would be Chan 1 with my 100 watt rig and a hundred miles on even less power.
But as the frequency goes up even wet leaves get in the way.
In the old ANALOG days, the channel number on the dial determined the frequency
But in today's DIGITAL world.. Well.
In Detroit, MI.. Chan 2 (2-#) broadcasts on the old Chan 7 Frequency (177 MHZ) not 56 like they used to,, Chan 7 uses chan 41. Chan 20, uses 21 (not much change) but ... Well,, Many VHF stations are now broadcasting in the UHF band.
The basic Batwing, though a good antenna, is a bit weak in the UHF, adding a Wingman fixes that.. Adding a Sensar Pro inside gives even more improvement
The biggest change however was this. A station that used to run say 100,000 watts, May now only be running 10-25 thousand. This means you need to be a bit more fussy in antenna pointing.
But remember,,, I push only 100 watts into my wire if taking on the radio, and about 30-40 if pushing digital... and I talk to other hams around the country, and type (digital) to hams all over the world. WITH 1/3 the power I use on voice.
Home was where I park it. but alas the.
2005 Damon Intruder 377 Alas declared a total loss
after a semi "nicked" it. Still have the radios
Kenwood TS-2000, ICOM ID-5100, ID-51A+2, ID-880 REF030C most times