cancel
Showing results forย 
Search instead forย 
Did you mean:ย 

Exterior sticker residue

kfp673
Explorer II
Explorer II
How do I get it off? Our camper is two years old now and I never bothered to get residue off from a sticker that I guess was on it at the dealer. I'm sure GooGone will get it off but I'm scared it could damage the clear coat. Any thoughts?

Thanks!
12 REPLIES 12

Thermoguy
Explorer II
Explorer II
If it isn't that bad, Windex with ammonia will work and will not damage anything. I have used goo gone on my cars with no issues with clear coat. Just do a small amount at a time and don't forget to apply wax when you are done. Many of those things will take the wax off.

Veebyes
Explorer II
Explorer II
I did not start my day today with intentions of removing old decals but the job sort of presented itself so it got done.

The job was cracked & dried out decals on the engine cowling of a 12 year old outboard that has never been covered.

Step 1 was a heat gun & a not very sharp putty knife. This took the decals off as easy as can be.

Step 2 was a terry towel soaked with acetone. This took the residual glue off dead simple & clean.

Step 3, a cleaner wax treatment. Looking pre decal new.
Boat: 32' 1996 Albin 32+2, single Cummins 315hp
40+ night per year overnighter

2007 Alpenlite 34RLR
2006 Chevy 3500 LT, CC,LB 6.6L Diesel

Ham Radio: VP9KL, IRLP node 7995

Super_Dave
Explorer
Explorer
kfp673 wrote:
Thanks all. I figured all of the above would work but was concerned they would damage the clear coat. I have a few of the above around the house so I'll try them sparingly and see how it goes. Thanks again!


These typically remove any wax that was on the siding but not the clear coat. Applying some new wax afterwards would be a good idea.
Truck: 2006 Dodge 3500 Dually
Rig: 2018 Big Country 3155 RLK
Boat: 21' North River Seahawk

Grit_dog
Navigator
Navigator
Depends what the siding is. Aluminum powder coat, be more careful. Painted or gel coat surfaces, acetone or anything weaker than that won't damage anything.
FLat razor blade will scrape off most of it.
Options ot remove the rest of the residue, everything mentioned so far, or an eraser wheel if you have a bunch to do or the right situation needing that.
2016 Ram 2500, MotorOps.ca EFIlive tuned, 5โ€ turbo back, 6" lift on 37s
2017 Heartland Torque T29 - Sold.
Couple of Arctic Fox TCs - Sold

kfp673
Explorer II
Explorer II
Thanks all. I figured all of the above would work but was concerned they would damage the clear coat. I have a few of the above around the house so I'll try them sparingly and see how it goes. Thanks again!

RetiredRealtorR
Explorer
Explorer
donkeydew wrote:
w-d 40 will take it off


X2......and you probably already have some!
. . . never confuse education with intelligence, nor motion with progress

noteven
Explorer III
Explorer III
3M automotive adhesive remover spray can used as per instructions.

Veebyes
Explorer II
Explorer II
Acetone, Lacquer thinner, many expensive products for cleaning.
Boat: 32' 1996 Albin 32+2, single Cummins 315hp
40+ night per year overnighter

2007 Alpenlite 34RLR
2006 Chevy 3500 LT, CC,LB 6.6L Diesel

Ham Radio: VP9KL, IRLP node 7995

IAMICHABOD
Explorer II
Explorer II
Having tried quite a few including all that have been mentioned here so far I have found that Rapid Remover out performs them all and wont damage the clear coat.
2006 TIOGA 26Q CHEVY 6.0 WORKHORSE VORTEC
Former El Monte RV Rental
Retired Teamster Local 692
Buying A Rental Class C

wildtoad
Explorer II
Explorer II
Professional goof off
Tom Wilds
Blythewood, SC
2016 Newmar Baystar Sport 3004
2015 Jeep Wrangler 2dr HT

donkeydew
Explorer
Explorer
w-d 40 will take it off

rk911
Explorer
Explorer
goo gone. works wonders.
Rich
Ham Radio, Sport Pilot, Retired 9-1-1 Call Center Administrator
_________________________________
2016 Itasca Suncruiser 38Q
'46 Willys CJ2A
'23 Jeep Wrangler JL
'10 Jeep Liberty KK

& MaggieThe Wonder Beagle