โSep-30-2013 08:42 AM
โSep-30-2013 04:37 PM
โSep-30-2013 03:47 PM
โSep-30-2013 12:40 PM
MEXICOWANDERER wrote:
No problem. Your rotors were cast and machined down here in Mexico in the city of Monterrery, Nuevo Leon. Or in a suburb. Want boring nomenclature? The iron was cast in Monclova. Nuevo Leon. Gad I've been down here too long ๐
Your original rotors were hybrid metric (bearings) and US standard (inches) for rotor dimensions. Not the new rotors, they are all metric - to the closest mm match to the original inch measurement. They didn't want to be accused of "cheating" so they "rounded up" instead of "down" with the mm's.
โSep-30-2013 12:38 PM
SuperDutyFiver wrote:
Was there a lot more meat on the disc than your old rotor or is the gap between the two surface greater?
I'm amazed that the dust shiedl hasn't rusted away and that you could even get the bolts off!
โSep-30-2013 12:21 PM
โSep-30-2013 09:53 AM