Aug-22-2020 03:52 PM
Aug-28-2020 09:35 AM
anutami wrote:
Thanks for all the replies and suggestions
Now I’m scratching my head, I removed the table leg insert and there appears to be reinforced with more plywood than I thought but could this just be around the table legs or is the entire floor have this much wood? I find it hard to imagine they reinforced the table legs but the area that sees the most use gets a thin piece of luan
I don’t think I will have much clearance for this storage nook if I put another type of flooring down so now back to the drawing board.
I guess I will just have to live with a soft floor 😞
Aug-28-2020 08:41 AM
Anutami wrote:
Pretty sure the top layer of 1/4" luan has weakened and its pushing into the foam layer. The underside luan portion is holding strong. I think the only way to tackle this is from the top side.
Aug-24-2020 08:31 PM
anutami wrote:
Thanks for all the replies and suggestions
Aug-24-2020 08:04 PM
Camper_Jeff_&_Kelli wrote:
Is this the same camper?
Aug-24-2020 07:47 PM
Aug-24-2020 07:13 PM
Aug-24-2020 06:29 PM
Aug-23-2020 09:54 PM
Aug-23-2020 06:19 PM
anutami wrote:
Pretty sure the top layer of 1/4" luan has weakened and its pushing into the foam layer. The underside luan portion is holding strong. I think the only way to tackle this is from the top side...
Aug-23-2020 04:49 PM
anutami wrote:
at 15:35 you can see what the floor looks like, it appears the arctic fox is much thicker than the WC
https://www.youtube.com/watch?v=x9rmC2iacvI
Aug-23-2020 04:45 PM
deltabravo wrote:
I am not terribly convinced that Northwood would use a 1/4 piece of plywood as the floor material. That thin of wood won't support much weight at all.
Aug-23-2020 04:25 PM
Aug-23-2020 12:27 PM
jimh425 wrote:
It doesn’t look like it’s damaged. Have you thought about adding cross bracing from below? That would probably be a lot easier. But, I’d still give the manufacturer a shout.
Aug-23-2020 10:39 AM
jimh425 wrote:
It doesn’t look like it’s damaged. Have you thought about adding cross bracing from below? That would probably be a lot easier. But, I’d still give the manufacturer a shout.