Finally got around to installing a screen on the side cargo door. The factory supplied screen by BugBarrier is a great screen and heavy duty mesh, but when it comes to unzipping and re-zipping to get in and out it is a pain. Besides which, the velcro hook pieces were separating from the glue strips leaving a sticky mess on the doorway.
This mess was cleared up eventually, but not before trying heat, goop, mineral spirits and finally WD40 & Methyl Hydrate alternately on rags and lots of elbow grease.
The new screen, Magic Mesh,bought at a local hardware store, has more info at www.magicmeshinfo.com. There are two panels. The LHS panel was installed full width, which put the opening in the centre of the door walkway (the rear of the two side doors remains closed and is used for the left hand edge of the LHS panel). The RHS panel needed to be cut off on the RHS. Both panels were too long and were shortened. Because the sticky tape comes through the mesh on the RHS panel, electrical tape was used to cover each one. The original Velcro strips were about 4 inches long, but were cut in two to provide a better fit for the mesh over the curves of the van body. The raw panel edges will be sealed with carpet tape or something similar.
"Drive with Care, Life has no Spare!"
2008 Roadtrek C190V 6.0L Hella Fog, Nighthawk Driving, Halogen Reverse Lights, Fiamma Air Horn, Firestone Air Bags, Custom Bed & Mattress, Custom O/Head Tray. website www.sen-f.ca