How to replace a Winegard Sensar antenna head
Get the new head (I recommend a Sensar IV)
Raise antenna.. Point toward near side of RV (Wings extend to the sides of where the thing points to)
Disconnect the coax cable (A 7/16" Wrench may be helpful) and let hang
Remove two pins (They have spring pins that lock them in) Needle nose pliars may be helpful
Set old head aside
Align new head with the one arm and insert pin and pin it
Slign other arm with other hole insert pin and pin it
Attach coax cable
Point towards TV transmitters and test...
Return to "Home" position lower and job done.
Job done.
Suggestion: IF you have a problem tearing it off when driving forward (not sure Id' do this for backing) Put a standard Camco or equivlent vent cover just in front of it to either take the blow or lift the small limbs up over the top of the antenna.. They will then fall back onto it but should slid off without harm (I hope).
Home was where I park it. but alas the.
2005 Damon Intruder 377 Alas declared a total loss
after a semi "nicked" it. Still have the radios
Kenwood TS-2000, ICOM ID-5100, ID-51A+2, ID-880 REF030C most times