โFeb-09-2014 06:36 AM
โFeb-10-2014 12:12 PM
itzaqueen wrote:
Doug
It is a 1997 Hurricane Class A motor home. It had carpet and we took it out and installed a thin laminate wannabe pergo. It slides over it nicely, but leaves a small scrape at each end roller. But now that the glide has been tapered with, it's hard to say it would work at all. But thanks for your response.
โFeb-10-2014 08:54 AM
โFeb-09-2014 06:39 PM
โFeb-09-2014 04:55 PM
โFeb-09-2014 02:45 PM
โFeb-09-2014 07:41 AM
โFeb-09-2014 06:51 AM
itzaqueen wrote:
This is in regards to my new laminate floor. The slide that goes over it scratches. But now there is another issue.
My husband and another guy decided to just take that strip of Teflon? resin-like material, off the front of the slide where it touches the floor. Obviously it's a very tough material, so they proceeded to bang on it, thinking if they got it out the slide would be lifted enough to not scrape (their other idea was to torch it out, smart)
Well, to make matters worse,It now won't even slide because it is too tight to the floor in one corner where they did all the banging. I've been reading the comments about what to do to help the slide go over the laminate, but I was too late, the banging went on first. And late.
Then, to make matters worse, my husband decided to try to push the plastic strip back inside the area where it slides, so now all the plastic in the one corner is jammed into the area where it comes in and out. Needless to say, it won't slide out anymore.
Does anyone have any ideas besides calling an RV repair?
โFeb-09-2014 06:47 AM
โFeb-09-2014 06:45 AM
โFeb-09-2014 06:42 AM