Help
Technical Issues
Having RV issues? Connect with others who have been in your shoes.
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 

Conversations

Start a conversation

Adjusting Slideout

In another thread, I mentioned that I'm replacing all of my seals around my slideout. While inspecting the slideout itself, I noticed that it's out of adjustment so I'll be doing that as well. Probably why it squeals so horribly! For those of you tha...

RobWNY by • Explorer
  • 1152 Views
  • 6 replies
  • 0 likes

Wiring Diagram 2008 Dutchmen Denali 295BS TT

Trying to help a fellow camper... This Travel Trailer has two slides on the Driver Side. Rear tire on that side tossed a tread. Tore down the Wiring on the Living Room Slide.Here are the wiring sizes and colors. Easy to ID, all out of their sheathing...

j-d by • Explorer II
  • 739 Views
  • 2 replies
  • 0 likes

10 gal suburban DSI water heater won't start

Last time used may 2016. Furnace works, stove works (so I do have propane)When I turn on switch from inside RV I can hear the spark thing making clicking noise but it doesn't fire off. Clicking stops and then tries again and again. I'm thinking spi...

path1 by • Explorer
  • 1512 Views
  • 12 replies
  • 0 likes

White square drive counter sunk RV screws needed

I have some screws in my Lance TC that don't tighten up properly and I would like to replace them with longer and maybe larger diameter screws. I cannot find any that are larger then #8 and none of them are the flat head, counter sunk screw like are...

pirlbeck by • Explorer
  • 4167 Views
  • 25 replies
  • 0 likes

'Sharp' over stove convection/microwave oven problems

While on a trip last fall, something strange happened to the unit. While trying to convection heat a few potatoes, the oven would stop heating at one minute. Tried another way with microwave, unit runs one minute and shuts down. We 'can' hit the star...

Kisae SW2420 PSW Inverter 24VDC-120VAC

Just got it and opened it up. Haven't tried it yet. Manual: http://www.kisaepower.com/wp-content/uploads/2016/07/SW2420-Series-REV-B.pdfThe construction looks pretty solid to my untrained eye.Not sure about the electronics. Lots of LG branded capacit...

brulaz by • Explorer
  • 2593 Views
  • 28 replies
  • 0 likes

Water heater problem

I went to use my hot water this weekend and nothing came out of hot side, turned faucet on and nothing came out, water tank is full, anyone have any thoughts?

scmajm by • Explorer
  • 2154 Views
  • 15 replies
  • 0 likes

Truma Aquago Hot Water Heater FYI

Went to take a shower in our new MH that has the Truma Aquago Endless Hot Water Heater this weekend and the hot water would only get luke warm. Too cool to take a shower. Two weeks ago, it worked just fine. The trouble shooting begin and after abou...

Trojan T-125's finally gone

Well almost. After 14 years a heavy use, usually 25 to 50 or more discharges to 25 percent SOC each year they are finally ready to get recycled. This year I couldn't get the voltage up past about 6.9V when trying to equalize them, and SG is dow...

ktmrfs by • Explorer
  • 2500 Views
  • 14 replies
  • 0 likes

Running a BriskAirII A/C on a Yamaha 2400iSHC Genny !

After a long time and a couple unsuccessful tries, there is a very strong solution to doing this without incurring the brown-outs associated with a Capacitor-based type solution. Started with the capacitor based solution...Dometic Quick Start or a S...

Norcold li op code, but reset by itself?????

I have the Norcold Polarmax 2118 in my 2016 Bighorn. Today, in humid weather after a heavy downpour, the fridge started beeping with the dreaded li op code.I had this code once when the rig was new, and found insulation blocking the vent. Cleared the...

NHIrish by • Explorer
  • 1620 Views
  • 3 replies
  • 0 likes

Carpet on fiberglass ceiling? Condensation?

Hi folks!My new van has a fiberglass high top, lined with carpeting. I am wondering if I should tear out the carpet and just paint it. This would be a lot easier to do now, in the build stage, rather than after the interior is finished and I am actua...

Naio by • Explorer II
  • 2189 Views
  • 11 replies
  • 0 likes

Norcold N81 now a "nocold"

I was at our site at Lake Fork today & found our Norcold N81 not getting cold . I am heading back over tomorrow with my meter/tools to check out. The lights show I have 120/12 volts & the burner will light but didnt have time to see if gets cold on ...

sayoung by • Explorer
  • 1021 Views
  • 3 replies
  • 0 likes
Top Liked Authors
View all
  • Facebook
  • Twitter
  • YouTube
  • Instagram
  • Pinterest