Technical Issues
Having RV issues? Connect with others who have been in your shoes.
cancel
Showing results for 
Search instead for 
Did you mean: 

Conversations

16 oz propane refill

who if anyone does the refill your own 16 oz propane cylinder? In advance, just opinions, comments, concerns, experience, etc. I am thinking about filling my own. So blast me with your thoughts and experience. Thanks in advance, Good Luck & Be Safe !...

jffnkrn by Explorer
  • 909 Views
  • 3 replies
  • 0 likes

Dometic Sealand Toilet Leak

My Dometic Sealand toilet leaks when the lever is raised to fill the bowl. In the picture, there is a black seal in the middle with a brass pipe above it. I removed the plastic cover for the arm that fills and empties the bowl to see this. Water gat...

ncrowley by Explorer II
  • 2733 Views
  • 6 replies
  • 0 likes

MCD Motorized Privacy Shade Issue

2016 Itasca Suncruiser 38Q-U1. Having trouble with the front motorized MCD privacy shade. The shade goes up and down well enough but after each day's travel it creeps down a fraction of an inch. We've been on the road since early March and the pri...

rk911 by Explorer
  • 555 Views
  • 1 replies
  • 0 likes

REPLACEMENT SCREEN DOOR SLIDE

I am trying to find a replacement screen door slide for our MH. I need one that is 11-11/16" high x 11-7/8" wide x 1-3/4" deep. I ordered one from Valterra not thinking about the depth and it is only 1" deep. There is a circle with the wording Phi...

Onboard Fresh Water System

Montana 2014 High Country. Traveling and last night only had electric hook-up. Water tank at least 1/2 full and pump runs but only spits air and drops of water from faucets. Night before last tank water level had been very low.. Back home now ...

Braces by Explorer
  • 1924 Views
  • 8 replies
  • 0 likes

How to remove circuit board?

I have a Dometic RM2652 Fridge and I think this is the lower control board and cover. I'm not all that mechanical and I can't figure out how to get it off to take it in and have it tested. I removed the upper screw, but can't seem to remove the cov...

Sizing jack stands for wind load?

I often camp in windy places. In my current, small van, I sometimes have to lift the tires off the ground to get stability. I use jack stands that are each rated for my whole gvw, to allow for the increased load with wind gusts. 45 mph gusts are co...

Naio by Explorer II
  • 4130 Views
  • 12 replies
  • 0 likes

Dogbone Melted

Have any of you guys seen anything like this. My 2010 Jayco has 50 amp service and is usually hooked up to power to keep the batteries charged with a 50-30 amp and a 30-20 amp dog bone adapters. In this particular instance there has been no power dra...

Re-igniter - where does yellow wire go?

Hello All - in trying to diagnose / fix Dometic RM2652 propane operation issues I accidentally pulled the yellow wire off the re-igniter. There were only 3 wires total, and the only one disconnected was the yellow. Does anyone know if it goes on th...

Converter / Charger question

Please help me understand my converter / charger in my TT2007 R Vision Max Lite TT ML 28RSAtwood model # TP3-55530SSI was de winterizing the TT the other day and I got a new battery (battery date code was 3/17) because the other one was shotI hooked ...

NJ6PACK by Explorer
  • 3422 Views
  • 12 replies
  • 0 likes

Transfer Switch WFCO T-57 ??

I just installed a T-57. Incoming 50 amp shore power thru surge protector to the T-57 transfer switch. Black to L1- Red to L-2 on the T-57. Works great when on shore power. On the generator side , white to neutral, gr to gr, black (HOT) lead to L2,...

WE-C-USA by Explorer
  • 4247 Views
  • 9 replies
  • 0 likes

Making a strong seam in galvanized sheet?

I'm making a thingy, and I thought one of you guys might be able to advise :B..It's for a small garden bed. I want to take some 6 or 8" galvanised flashing and make a ring. The seam needs to be strong enough to resist the outward pressure of around ...

Naio by Explorer II
  • 6584 Views
  • 30 replies
  • 0 likes

Black valve leaks

On our 2015 Montana 5ver, when the black valve is closed exit pipe continues to drip. There seams to be some kind of debris in seal preventing it from completely sealing. Is there any kind of chemical or other suggestions to fix this without replac...

TCI by Explorer
  • 1556 Views
  • 5 replies
  • 0 likes

Troubleshooting failed solar - Water in your junction box

So, my renogy solar panels stopped working. After some digging, I found a small amount of water in my junction box on the roof. I think some snow and ice created havoc up there and some how leaked into my junction box. I thought I had sealed it prett...

kp_utah by Explorer
  • 5497 Views
  • 29 replies
  • 0 likes